Home network cabling for Dubai villas: what to wire before you move in

A villa needs the same kind of network an office does, on a smaller scale. Here is what to wire before you move in, how a new build differs from a finished home, and a checklist for the installer.

Small network cabinet in a villa with a router, switch, Cat6 cables and a UPS

What home network cabling covers in a villa

Home network cabling in a villa means a wired Cat6 point wherever a TV, computer or camera sits, a ceiling Wi-Fi access point on every floor, and one small cabinet where all the cables meet. It is the same structured cabling an office gets, on a smaller scale, and it is far easier to install before you move in than after.

Onexpertis installs network cabling in villas and homes as well as offices, planned on the floor plan, tested and labelled. This guide covers what to wire, how a new villa differs from a finished one, and a checklist to take to any installer.

Cat6 to the rooms that need it

Run Cat6 to every place where a device stays put and uses a lot of data: TVs, computers, games consoles and a work-from-home desk. Wired devices stop competing for Wi-Fi, which leaves the wireless network free for phones and tablets.

SpaceWhat to wire
Living room and majlisThe TV wall, and a ceiling point for an access point
BedroomsThe TV wall and any desk
Study or home officeThe desk, with a spare point beside it
Each floorA ceiling point for a Wi-Fi access point
OutsideCamera points at the gate, driveway, doors and garden boundary, and the intercom at the entrance
CabinetWhere every run ends, next to the incoming internet line

Cat6 or Cat6A?

Cat6 suits TVs, desks and cameras in most homes. Cat6A is worth it for high-capacity Wi-Fi, or when you want the cabling to outlast several generations of equipment.

FeatureCat6Cat6A
Speed over 100 m1 Gbps10 Gbps
10 Gbps reachAbout 55 mFull 100 m
Cable sizeThinner, fits tight trunkingThicker, needs more space
CostLowerHigher, for cable and termination

Wi-Fi access points on every floor

Fit a ceiling access point on each floor, wired back to one switch, instead of relying on a single router to cover the whole villa. The signal then follows you from the bedroom to the majlis and out to the garden.

Concrete walls and floors absorb Wi-Fi, which is why one router in the living room often struggles to reach the top floor. Each access point needs a single Cat6 cable, which carries both data and power (PoE) from the switch, so the ceiling does not need a socket.

Add points for the outdoor areas you actually use, such as the garden, the pool or a roof terrace. Wi-Fi access points can be mounted on ceilings, walls or poles.

One cabinet for the router, switch, CCTV recorder and UPS

Bring every cable to one small cabinet that holds the router, a switch, the CCTV recorder and the smart home hub, with a UPS, instead of a pile of boxes behind the TV.

  • Patch panel: every room cable ends on a numbered port, so any point can be traced.
  • Switch: with PoE to power the cameras and access points.
  • Router: where the internet line from your provider connects.
  • CCTV recorder (NVR): stores the footage from the cameras.
  • Smart home hub: if you are adding automation, now or later.
  • UPS: keeps the network and the recorder running through a short power cut, so there is no gap in the recording.

Put the cabinet somewhere ventilated and easy to reach, such as a utility or store room, not a bedroom wardrobe. The equipment gives off heat and runs all day.

Points for cameras, intercom and automation

Wire for security and automation before you move in, even if you install the equipment later, because these points are the hardest to add once walls and ceilings are finished.

  • CCTV: each IP camera takes power and data over one cable from the PoE switch. Typical villa positions are the gate, driveway, front door, back door and garden boundary. See CCTV installation for villas.
  • Video intercom: a point at the gate or entrance, so you can see who is there on your phone and open the gate remotely.
  • Home automation: a wired system needs its control cabling run before the ceilings close, and the hub sits in the same cabinet. See home automation on the same network.

New villa or finished home: how the work differs

In a new villa, the cabling is planned from the drawings alongside your contractor. In a finished home, the installer inspects first and plans the neatest cable route before quoting.

StageNew villaFinished home
Starting pointThe villa drawingsAn inspection of the house
Who coordinatesThe installer works alongside your main contractorThe installer plans the route with you
Cable routeConduit laid before walls are plastered and ceilings closedExisting conduit, ceiling voids, or neat trunking where there is no other route
DisruptionPart of the build programmeSome drilling and ceiling access, agreed before work starts
When to callBefore first fixIdeally before you move in

A finished home can still be cabled neatly. It takes more planning, and the route decides what is practical in each room.

Checklist: what to prepare and ask before buying

Take a marked-up floor plan and these questions to any installer, and the quotes you get back will be comparable.

Prepare

  • A floor plan with TV, desk and console positions marked in each room.
  • The camera positions you want, and where the intercom goes.
  • Where the cabinet will go, and where the internet line enters the villa.
  • Which floors and outdoor areas need Wi-Fi.
  • Whether you plan home automation, now or later.
  • A few spare points beyond what you need today, because adding one later means opening walls or ceilings.

Ask

  • Is every cable tested, and will I see the results?
  • Do outlets and patch panel ports carry the same numbers, and do I get a drawing that shows them?
  • Cat6 or Cat6A, and why for each run?
  • What goes in the cabinet, and is a UPS included?
  • For a new villa: who coordinates with the contractor, and when do you need to be on site?

See how Onexpertis plans network cabling for villas and offices, or book a site inspection.

Questions

Do you also install office network cabling?

Yes. Onexpertis installs structured cabling for offices, warehouses and buildings: Cat6 and Cat6A to desks, cameras and access points, fibre between floors, and racks.

Can cameras and guests share the home network?

They can share the cabling and the switch while running on separate networks (VLANs). Guest Wi-Fi and cameras then stay apart from the family's computers.

Do I still need my internet provider's router?

Usually, yes. It brings the internet into the villa, sits in the cabinet and connects to the switch, which feeds the wired points and the access points.

Planning a villa network?

Send the floor plan and tell us where the TVs, desks and cameras will go, and we will work from the drawings or inspect the home and quote the cabling, cabinet and Wi-Fi.

+971 55 288 6114Call or WhatsApp, Monday to Saturday, 9:00 to 18:00
info@oneexpertis.comFloor plans and tender drawings welcome (PDF or DWG)
Al Wasl Building, Bur DubaiOffice 139, F5-B, Fifth Floor, near Bur Dubai Civil Defence
Please enter your name.
Please enter a number we can call, for example +971 50 123 4567.
Please choose the type of premises.

Sends your details to us on WhatsApp. We use them only to arrange your survey.

WhatsApp us